Allied Telesis AT-GS950/8 - Manual (Page 180)

Chapter 13: Virtual LANs
180
4. Use the State radio buttons to select the Private VLAN state:
Enabled - Will activate Private VLAN. The other parameters on the
web page will become active.
Disabled - Will de-activate Private VLAN. The other parameters on
the web page will become inactive and will be greyed out so that
data cannot be entered.
5. Click the Apply button at the upper right of the page.
6. From the main menu on the left side of the page, select Save Settings
to Flash to permanently save your changes.
Create a Private
VLAN
To create a private VLAN, perform the following procedure:
Note
Private VLANs must be Enabled before a specific Private VLAN can
be created. See “Enable or Disable Private VLAN” on page 179.
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select VLAN.
The VLAN folder expands.
3. From the VLAN folder, select Private VLAN.
The Private VLAN Page is displayed. See Figure 66.
4. Use the Source Port drop-down menu to select the source port.
All ports under Forwarding Ports are automatically selected, and the
source port is grayed out.
5. Select the forwarding ports:
To select individual ports, click the Clear button, then click one or
multiple check boxes under Forwarding Ports.
Note
You will not be able to select the check box for the source port.
To select all ports except the source port, skip to Step 6.
6. Click the Apply button under the forwarding ports.
The private VLAN is shown in the Port List table. In the Port Map
column, the source port is indicated first, followed by a comma and the
forwarding ports. For example, if you selected 02 as a source port, and
06, 07, and 08 as forwarding ports, the port map would indicate 2,6-8.