beautypg.com

Ipv6 traffic class mapping, Enable or disable ipv6 traffic class mapping – Allied Telesis AT-GS950/8 User Manual

Page 204

background image

Chapter 15: Quality of Service and Class of Service

204

IPv6 Traffic Class Mapping

You can create and delete entries for IPv6 traffic class mapping by
following the procedures in the following sections:

“Enable or Disable IPv6 Traffic Class Mapping”

“Create IPv6 Traffic Class Entries” on page 205

“Delete an IPv6 Traffic Class Entry” on page 206

Before mapping IPv6 traffic class priorities, you must disable the Jumbo
frame parameter on each port. See the Jumbo parameter definition in
“Displaying and Configuring Ports” on page 67.

Note
When Jumbo frames are enabled, IPv6 traffic class mapping cannot
be enabled.

Enable or Disable

IPv6 Traffic

Class Mapping

To enable or disable IPv6 traffic class mapping, perform the following
procedure:

1. From the main menu on the left side of the page, select Bridge.

The Bridge folder expands.

2. From the Bridge folder, select QoS.

The QoS folder expands.

3. From the QoS folder, select IPv6 Traffic Class Priority Settings.

The IPv6 Traffic Class Priority Settings page is shown in Figure 75.

Figure 75. IPv6 Traffic Class Priority Settings Page