Stack command confirmation prompt – Allied Telesis 8100S Series User Manual

Page 98

Chapter 5: Powering On the Switch

This confirmation prompt in Figure 43 is displayed.

Figure 43. STACK Command Confirmation Prompt

Caution

The STACK command resets the switch. If the switch is already
connected to a live network, some network traffic may be lost.

4. Type Y to change the switch’s ID number and reset the unit, or N to

cancel the procedure.

5. Wait for the switch to initialize its management software and

afterwards examine the Stack ID LED. The switch is ready for normal
network operations if its stack ID number is “0.” Refer to the AT-8100
Series AlliedWare Plus Command Line Interface User’s Guide for
instructions on how to configure the operating parameters. If the
number is not “0,” repeat this procedure.

*** Warning Stack renumbering requires immediate reboot ***
Stack will restart with new Device ID, all ports will
have new numbering and any port configurations will
probably be lost.

Renumber and reboot system ? (y/n):

This manual is related to the following products:

8100L Series