Allied Telesis 8100S Series - Manual (Page 101)

Stand-alone Switch Installation Guide for 8100L and 8100S Series Switches
101
 You need to assign your management workstation an IP address in
the 169.254.n.n subnet or your workstation must have access to
that subnet through routing devices.
Refer to the AT-8100 Series AlliedWare Plus Command Line Interface
User’s Guide for instructions on how to configure the switch for secure
HTTPS web browser management.
SNMP Refer to the AT-8100 Series AlliedWare Plus Command Line Interface
User’s Guide for instructions on how to configure the switch for SNMP
management. The switch does not have any default SNMP community
strings.
Specifying Ports
in the Command
Line Interface for
Stand-alone
Switches
The command line interface of the Local, Telnet, and SSH management
methods gives you the ability to configure all of the features and
parameters on the switch. Many of the commands have the PORT
parameter, which you use to identify the networking ports on the switch.
This parameter has the following format:
Figure 44. PORT Parameter in the Command Line Interface
The first number is the switch’s stack ID number. The stack ID number in
the PORT parameter for stand-alone switches is not the value 0 displayed
by the Stack ID LED. Rather, it is 1. Be sure to enter 1, not 0, as the stack
ID number in the PORT parameter when configuring stand-alone switches.
The slot ID value, which is used to specify slot numbers in a multi-module
chassis, does not apply to the 8100L and 8100S Series switches and
should always be 0.
The third value is a port number on the switch. You may specify only one
port number in a PORT parameter, but you may specify more than one
PORT parameter in many of the commands where the parameter is
supported.
Here is an example of the PORT parameter on a stand-alone switch. It
uses the INTERFACE command to enter the Port Interface mode for ports
15 and 17:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.15,port1.0.17
port1 . 0 .n
Slot ID
Port Number
Stack ID