Horner APG ZX 752 OCS HE-ZX1152 - Manual (Page 6)

MAN0960-03-EN Specifications / Installation
__________________________________________________________________________________________________________________________________________________________________________
11/30/2011 #1037
7
Safety
No part of this publication may be reproduced without the prior agreement and written permission of
Horner APG, Inc. Information in this document is subject to change without notice.
WARNING: To avoid the risk of electric shock or burns, always connect the safety (or earth) ground
before making any other connections.
WARNING: To reduce the risk of fire, electrical shock, or physical injury it is strongly recommended to
fuse the voltage measurement inputs. Be sure to locate fuses as close to the source as possible.
WARNING: Replace fuse with the same type and rating to provide protection against risk of fire and
shock hazards.
WARNING: In the event of repeated failure, do not replace the fuse again as a repeated failure
indicates a defective condition that will not clear by replacing the fuse.
WARNING - Battery May Explode If Mistreated. Do Not Recharge, Disassemble or Dispose Of In Fire
WARNING: Only qualified electrical personnel familiar with the construction and operation of this
equipment and the hazards involved should install, adjust, operate, or service this equipment. Read
and understand this manual and other applicable manuals in their entirety before proceeding. Failure to
observe this precaution could result in severe bodily injury or loss of life.
 All applicable codes and standards need to be followed in the installation of this product.
 Adhere to the following safety precautions whenever any type of connection is made to the module:

Connect the safety (earth) ground on the power connector first before making any other connections.
 When connecting to electric circuits or pulse-initiating equipment, open their related breakers.
 Do not make connections to live power lines.
 Make connections to the module first; then connect to the circuit to be monitored.
 Route power wires in a safe manner in accordance with good practice and local codes.
 Wear proper personal protective equipment including safety glasses and insulated gloves when
making connections to power circuits.

Ensure hands, shoes, and floor are dry before making any connection to a power line.
 Make sure the unit is turned OFF before making connection to terminals.
 Make sure all circuits are de-energized before making connections.
 Before each use, inspect all cables for breaks or cracks in the insulation. Replace immediately
if defective.
Warning: Consult
user documentation. Warning: Electrical
Shock Hazard.
When found on the product, the following symbols specify:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.