Horner APG XLe OCS HE-XE103-10 User Manual
Page 4
PAGE 4
21 August 2007
MAN0848-02
XLE103-10
Specifications / Installation
7.
Safety
When found on the product, the following symbols specify:
8
Technical Support
For assistance and manual updates, contact Technical Support at the following
locations:
North America:
(317) 916-4274
www.heapg.com
email:
Europe:
(+) 353-21-4321-266
www.horner-apg.com
email:
Notes
Notes
All applicable codes and standards need to be followed in the installation of this product.
Adhere to the following safety precautions whenever any type of connection is made to the module:
Connect the safety (earth) ground on the power connector first before making any other connections.
When connecting to electric circuits or pulse-initiating equipment, open their related breakers.
Do not make connections to live power lines.
Make connections to the module first; then connect to the circuit to be monitored.
Route power wires in a safe manner in accordance with good practice and local codes.
Wear proper personal protective equipment including safety glasses and insulated gloves when making
connections to power circuits.
Ensure hands, shoes, and floor are dry before making any connection to a power line.
Make sure the unit is turned OFF before making connection to terminals.
Make sure all circuits are de-energized before making connections.
Before each use, inspect all cables for breaks or cracks in the insulation. Replace immediately if defective.
Warning: Consult
user documentation.
Warning: Electrical
Shock Hazard.
WARNING: To avoid the risk of electric shock or burns, always connect the safety (or earth) ground before
making any other connections.
WARNING: To reduce the risk of fire, electrical shock, or physical injury it is strongly recommended to fuse
the voltage measurement inputs. Be sure to locate fuses as close to the source as possible.
WARNING: Replace fuse with the same type and rating to provide protection against risk of fire and shock
hazards.
WARNING: In the event of repeated failure, do not replace the fuse again as a repeated failure indicates a
defective condition that will not clear by replacing the fuse.
WARNING: Only qualified electrical personnel familiar with the construction and operation of this equipment
and the hazards involved should install, adjust, operate, or service this equipment. Read and understand this
manual and other applicable manuals in their entirety before proceeding. Failure to observe this precaution
could result in severe bodily injury or loss of life.