Horner APG XLe OCS HE-XE102-62 User Manual
Page 4
MAN0907-01-EN
Specifications / Installation
__________________________________________________________________________________________________________________________________________________________________________
7/22/2009 Page 4 of 4 ECN # 958
10
Technical Support
For assistance and manual updates, contact Technical Support at the
following locations:
North America:
Tel: 317 916-4274
Fax: 317 639-4279
Web:
http://www.heapg.com
Email:
Europe:
Tel: +353-21-4321266
Fax: +353-21-4321826
Web:
http://www.horner-apg.com
Email:
No part of this publication may be reproduced without the prior agreement and
written permission of Horner APG, Inc. Information in this document is subject
to change without notice.
For detailed installation and a handy checklist that covers panel box layout
requirements and minimum clearances, refer to the hardware manual of the
controller you are using. (See the Additional References section in this
document.)
All applicable codes and standards need to be followed in the installation of
this product.
Adhere to the following safety precautions whenever any type of connection
is made to the module:
Adhere to the following safety precautions whenever any type of connection is
made to the module.
Connect the safety (earth) ground on the power connector first before
making any other connections.
When connecting to electric circuits or pulse-initiating equipment, open their
related breakers.
Do not make connections to live power lines.
Make connections to the module first; then connect to the circuit to be
monitored.
Route power wires in a safe manner in accordance with good practice and
local codes.
Wear proper personal protective equipment including safety glasses and
insulated gloves when making connections to power circuits.
Ensure hands, shoes, and floor are dry before making any connection to a
power line.
Make sure the unit is turned OFF before making connection to terminals.
Make sure all circuits are de-energized before making connections.
Before each use, inspect all cables for breaks or cracks in the insulation.
Replace immediately if defective.