MagTek IntelliStripe65 99875161 - Manual (Page 23)

Section 4. Magnetic Stripe Application
17
DECODE JIS TYPE 2 PROPERTY
Property ID: 15 (Hex)
Property Type: Boolean
Power Up/Reset Value: 0 (False)
Get/Set/Save support: All
Description:
If this property is set to true then cards encoded to JIS X 6302 type 2 standards can be decoded.
Values:
Value Decode JIS Type 2
0 False
1 True
Example Set Property Request:
Field MTYP APPL CMND RC PTYP PID PVAL
Byte 1 2 3 4 5 6 7
Value (Hex) 00 01 01 00 03 15 01 (True)
Example Set Property Response:
Field MTYP APPL CMND RC
Byte 1 2 3 4
Value (Hex) 40 01 01 00
CLEAR DATA COMMAND
Command ID: 80 (Hex)
Description:
This command is used to clear all magnetic stripe data so that the data can no longer be acquired
from the device. After this command is issued, no magnetic stripe data will be available until a
card is read.
After a card is read, the magnetic stripe data is held in the device until:
1.
Another card read occurs.
2. A Clear Data command is issued.
3. The device is power cycled or reset.
Request Message Data: None
Response Message Data: None
Response Message Result Codes:
Success = 00 (Hex)
The command completed successfully.