AMETEK 2110 Shut Height Monitor User Manual
Page 57
Installation and Programming Manual
52
Appendix A: Error Messages
53
Installation and Programming Manual
Appendix A: Error Messages
The following errors will cause the upper and lower limit relays to de-energize:
Chart A-5 Upper and Lower Limit Relay Errors
The following chart contains a resolver-specific error:
Chart A-6 Resolver-Specific Error
Error Displayed
Error Description
SEr320
This is a resolver-specific error. See Chart A-6.
SEr330
The input device is not connected to the monitor's input module.
SEr331
This is a LDT-specific error. See Chart A-7.
OEr101
The press's ram did not move within the time programmed in the Move
Detection Time-Out function.
OEr330 or
OEr320
The press's shut height moved beyond the value programmed in the Nega-
tive Over Travel Limit functions.
Error Displayed
Error Description
Solution
SEr320
The cable may not be connected, an
open or short may exist in the cable,
or the resolver's primary may be
open or shorted.
To determine the exact condition,
enter the Error Conditions function
(306). For instructions, see Error
Conditions (306) following this
chart.
T13692 appendix a.indd
3/17/04, 6:54 AM
53