AMETEK 2110 Shut Height Monitor - Manual (Page 46)

Installation and Programming Manual 42
Chapter 4: Programming
43 Installation and Programming Manual
Chapter 4: Programming
Logic Level (202)
This function will set up selection of either high true or low true.
1. Select the function key.
The monitor displays “F-----”
2. Enter function 202. Select the enter key.
The monitor displays the function’s current value.
3. Enter either 0 or 1.
0 = Low True
1 = High True (default)
Select the enter key.
Latch/Synchronize Handshake (201)
The function defines which of the two methods will be used to stabilize position data while
the PLC reads. The two options are Latch or Synchronize Handshake. Synchronize Handshake
tells the digital board to update on the transitional edge of a clocked square wave input (pin
24). Latch tells the digital board to update continuously until the latch input pin is activated by
driving high, then the outputs will freeze.
NOTE: If set for Synchronize handshake, the position data will never update if a square wave
input is not seen on pin 24.
1. Select the function key.
The monitor displays “F-----”
2. Enter function 201. Select the enter key.
The monitor displays the function’s current value.
3. Enter either 0 or 1.
0 = Latch (default)
1 = Synchronize
Select the enter key.
Enter either
0 or 1
201
Enter either
0 or 1
202
(F)
8
8
(F)
8
8
T13692 Chapter 4.indd 3/17/04, 6:50 AM 42