Vaisala Hydromet Data Collection Platform - Manual (Page 181)

Chapter 4 ________________________________________________ Configuring Telemetry Options
VAISALA______________________________________________________________________ 179
Reading Settings and Diagnostics Information
The settings and diagnostics information of the transmitter can be read
by giving the following command in the service terminal:
DO
A response to each command can be read by giving the following
command:
LASTVAL <name> service
As an example, the transmitter ID ("010012D4") can be read as follows:
/ > DO GOES_1 getid
/ > LASTVAL GOES_1 service
Status:1 Value:010012D4
/ >
where
name
= Name of the transmitter as given in Lizard, for
example, GOES_1
command = Any of the commands presented
in
Table 21 on page 179
Table 21 Diagnostics Commands
Command Description
reset Resets the transmitter.
run_diag Executes the transmitter self-test.
show_diag Reads the results of the previous self-test.
version Reads the version information of the transmitter.
getid Reads the transmitter ID currently in use.
getid_eeprom Reads the ID stored in the transmitter EEPROM.
getclock Reads the transmitter clock.