Vaisala Hydromet Data Collection Platform - Manual (Page 115)

Chapter 3 _____________________________________________ Configuring Modules and Sensors
VAISALA______________________________________________________________________ 113
Configuring Sensor Interface
Serial sensors have and use their own configuration interfaces. In
addition to defining the communication parameters, there is typically
very little to configure with Lizard Setup Software.
Proceed as follows:
1. Add and configure the communication interface module using the
Optional hardware view as shown in
Figure 59 on page 113 .
0711-139 Figure 59 Optional Hardware View: Configuring
Communication Module
NOTE Use the default communication parameters of the sensor. These are not
automatically generated by Lizard Setup Software, so you need to
enter them manually.