Table 15, Available output variables, Lists the available output – Vaisala Hydromet Data Collection Platform User Manual
Page 160: Table 15 available output variables

User's Guide ______________________________________________________________________
158 _________________________________________________________________ M210933EN-C
Table 15
Available Output Variables
Variable
Data Type
Description
check_errs
Integer
Number of the failed downlink checksums
conn_GCC
Integer
Number of the connected ground stations (GCC)
inbound_message
String
Content of the latest inbound message
inbound_sender
String
Sender of the latest inbound message. If the sender is listed
in the speed dial list in the GCC, only the number is
available instead of the full internet address, for example,
OR08
inbound_subject
String
Subject of the latest inbound message
inbound_time
String
UTC time when the latest inbound message was received
lat
Float
Latitude from GPS
lon
Float
Longitude from GPS
msg_num
Integer
Number of the next message to be sent to the
communicator (SC). For example, when two messages
have been sent to communicator, the value is three
pass_msg_num
Integer
Number of the message that has been acknowledged by
gateway last, i.e., successfully transmitted. Value is
available after first transmission. Not applicable with
globalgrams.
pos_qual
Integer
Quality of the position information:
0 = GPS
1 = Good doppler ...
15= Poor doppler
qi_msgs
Integer
Number of inbound messages in SC
qo_msgs
Integer
Number of outbound messages in SC
sat_in_view
Integer
The ID number for the currently visible satellite. Zero if none
is visible.
sr_status
Integer
Status code from the last system response. The code is
available after first transmission. For details, refer to the
Orbcomm specification.
st_diag_code
Integer
Internal diagnostic code. For values, refer to the Orbcomm
SC specification.
status
Integer
General interface status:
0 = OK
1 = SC not accessed yet
2 = Reserved for future use
3 = Communication timeout
4 = Reserved for future use
5 = SC reports internal failure
6 = SC queue full
stored_sats
Integer
Number of the stored orbital elements. This indicates how
many different satellites the SC has acquired.
UTC
String
Current UTC date and time from GPS. Example: Thu Nov
01 11:35:16 2007