DAVIS Wireless Repeater (7626, 7627) - Manual (Page 20)

17
On the Console:
1. Press DONE and the down arrow (-) to enter Setup Mode. Screen 1 lists active
transmitters. This screen displays only the active transmitter IDs the console is
receiving. Wireless repeater identification is not displayed on this screen.
The transmitter ID for the station set on the repeater should display on this screen, with the number displaying
above the ticker tape and an “X” flashing on the bottom right of the console screen.
Note: It may take several minutes for the console to acquire repeated station. If the transmitter ID does not dis-
play in this screen after 10 minutes, see “Maintenance and Troubleshooting” on page 36.
2. Press DONE to display Screen 2: Configuring Transmitter IDs. See the example
screen below.
3. Select the transmitter ID transmitting through the repeater using the right (>) and left
(<) arrows. If the station does not already have its station type selected, do so now by
pressing the up (+) arrow until “ON” displays on the screen. Change the station type
by pressing GRAPH until the correct station type displays.
Note: The way the repeater ID information is accessed depends on the firmware version available on the con-
sole. If the firmware is dated May 2005, the repeater ID is accessed by pressing WIND. If the firmware is
dated October 2005 or later, the repeater ID is accessed by first pressing 2ND and then WIND, and
WIND again for any subsequent change. Follow the instructions below based on your console’s firm-
ware.
4. For consoles with May 2005 firmware, press WIND to turn the repeater function on
and to select a repeater ID. Pressing WIND sets the console to receive the signal from
a repeater instead of directly from a station. The first repeater ID displayed is repeater
A.
For consoles with October 2005 firmware or later, press 2ND and then press WIND to
enter Repeater Setup Mode and to select or deselect a repeater ID. Once the console is
in the Repeater Setup Mode, subsequent pressing of WIND continue to cycle through
the all the repeater IDs.
5. Press WIND repeatedly to cycle to the desired repeater ID or to turn off the repeater
ID in the right hand corner. When no repeater ID is shown, the console is configured
to listen directly to a station and not to a repeater.
Note: If a transmitter ID is turned off, pressing WIND or 2ND and WIND will not display the repeater ID.
STATION NO.1 4
STATION NO.1