DAVIS Sensor Mounting Arm for GroWeather, EnviroMonitor, Weather Monitor & Wizard - Manual (Page 8)

Page 8 Sensor Mounting Arm
8. Slide the anemometer arm backwards/forwards until the end of the anemometer arm
extends just 1/2” (13 mm) past the second U-bolt/saddle.
P OSITION A NEMOMETER A RM
9. Once the anemometer arm is correctly positioned, tighten the hex nuts.
In order to keep the anemometer arm steady in high winds, tighten the hex
nuts until you notice the anemometer arm just begin to buckle underneath
the U-Bolt.
10. Place a cable clamp around the anemometer cable.
11. Slide a #8-32 x 3/4”screw down through the indicated hole on the sensor arm.
A TTACH THE C ABLE C LAMP
12. Slide the hole in the cable clamp over the end of the #8-32 x 3/4” screw.
13. Secure the cable clamp and cable in place using an #8 flat washer and an #8-32 hex
nut.
Tighten the hex nut until the cable is held snugly within the cable clamp.