DAVIS Sensor Mounting Arm for GroWeather, EnviroMonitor, Weather Monitor & Wizard - Manual (Page 7)

Attaching the Anemometer Page 7
6. Slide the ends of the U-bolts into the appropriate holes at the end of the sensor arm
nearest the mounting bracket.
S LIDE U-B OLTS INTO H OLES
7. Secure the U-bolts and anemometer arm in place using a 1/4” flat washer, 1/4” split
lock washer and 1/4” hex nut on each of the U-bolt ends.
Tighten the hex nuts with your hand so the arm is gently held in place. Do
not tighten fully until instructed to do so later on.
A TTACH THE U-B OLTS AND A NEMOMETER A RM