DAVIS Sensor Mounting Arm for GroWeather, EnviroMonitor, Weather Monitor & Wizard - Manual (Page 13)

Mounting the Sensor Mounting Arm Page 13
Mounting the Sensor Mounting Arm on a Small Pipe
Follow the instructions below to mount the Sensor Mounting Arm on a pipe
with an outside diameter between 1” and 1-1/4” (25 mm and 31 mm). To
attach the sensor arm to a small pipe, you will need the sensor arm assembly
(with mounting bracket and sensors attached), two 1-1/2” U-bolts, four 1/4”
flat washers, four 1/4” lock washers, and four 1/4” hex nuts.
Note: When mounting on a small pipe, the Sensor Mounting Arm must be mounted at the top of the
pipe.
1. Position the mounting bracket (with sensor arm) against the pipe.
2. Slide the ends of one of the 1-1/2” U-bolts (so that the U-bolt wraps around the pipe)
into the holes on the mounting bracket.
3. Secure the U-bolts in place using a 1/4” flat washer, 1/4” lock washer, and a 1/4” hex
nut.
Tighten the hex nuts securely.
4. Repeat the procedure above for the other U-bolt.
M OUNTING ON A S MALL P IPE