DAVIS Sensor Mounting Arm for GroWeather, EnviroMonitor, Weather Monitor & Wizard - Manual (Page 10)

Page 10 Sensor Mounting Arm
7. Position the U-bolts/saddles on top of the sensor arm on the side farthest from the
mounting bracket so the ends of the U-bolts drop into the appropriate holes.
S LIDE U-B OLTS INTO H OLES
8. While holding the U-bolts in place, turn the sensor arm over so the protruding ends
of the U-bolts are visible.
9. Secure the U-bolts and anemometer arm in place using a 1/4” flat washer, 1/4” split
lock washer and 1/4” hex nut on each of the ends of the U-bolts.
Tighten the hex nuts with your hand so the arm is gently held in place. Do
not tighten fully until instructed to later on.
A TTACH THE U-B OLTS AND A NEMOMETER A RM