DAVIS Radiation Shield (7714) - Manual (Page 3)

1
Radiation Shield
(7714)
The radiation shield allows the temperature sensor to accurately measure air temperature
without the effects of direct radiation from sunlight.
Contents of Package
Tools and Materials Needed
• Small Phillips-head screwdriver and medium slotted-head screwdriver
• Wrench or pliers
• Drill with 3/16” (4.7 mm) drill bit
To drill pilot holes if attaching radiation shield to the top of a post.
• Adjustable wrench or 11/32” (8.6 mm) wrench and 7/16” (10.9 mm) wrench
To tighten hex nuts (11/32” wrench) or to drive lag screws into wall or post (7/16”
wrench).
Cover Plate
Flat Plate
Open Plates (3)
Closed Plates (3)
Support Plate
Wall Mount Bracket
1-1/2" U-Bolts
1/4" Flat Washers
1/4" Hex Nuts
1" (25 mm) Spacers 1/2" (13 mm) Spacers
Cable Clamp Cable Tie Clip Mounts
#8 x 5”
(127 mm long)
Threaded Studs
with Push Nuts
Installed
#8 x 2 3/4”
(70 mm long)
Pan Head Screws
#8 Flat Washers (12)
#8 x 1 3/4”
(44 mm long)
Pan Head Screws
#8 Split Lock
Washers (9)
#8 Hex Nuts (6)
#8 Wing Nuts (3)
#4 x 1/2”
(13 mm long)
Pan head
Self-Threading
Screws
#4 Flat Washers
Radiation Shield Parts
Installation Hardware Kit