DAVIS Radiation Shield (7714) - Manual (Page 13)

11
Mount the Radiation Shield
Follow the instructions below to mount the radiation shield. There are separate
sections for each of the mounting options. You should modify the instructions as
necessary to fit your needs.
Mounting on the Side of a Post or Wall:
In order to mount the radiation shield onto the side of a post or wall, you will need
the radiation shield assembly, three #8 split lock washers, three #8 flat washers,
and three #8 hex nuts. You will also need to supply four 1/4” x 1 1/2” (6.35 mm x
38.1 mm) lag screws.
1. Using four 1/4” x 1 1/2” lag screws (not included), attach the mounting bracket
to the mounting surface in the desired location.
2. Slide the stud ends protruding from the top of the radiation shield assembly
into the holes on the mounting bracket.
3. Secure the mounting bracket to the radiation shield using a #8 flat washer, #8
split lock washer, and #8 hex nut on each of the stud ends.
Tighten until the mounting bracket is firmly attached to the radiation shield.
#8 Lock Washer
#8 Hex Nut
#8 Flat Washer
Complete Plate
Assembly