DAVIS Radiation Shield (7714) - Manual (Page 14)

12
Mounting on a Pipe:
In order to mount the radiation shield onto a metal pip with outside diameter
between 1” and 1 1/4” (25 mm and 31 mm), you will need the radiation shield
assembly, three #8 split lock washers, three #8 flat washers, three #8 hex nuts, two
1 1/2” U-bolts, four 1/4” flat washers, and four 1/4” hex nuts.
1. Slide the stud ends protruding from the top of the radiation shield assembly
into the holes on the mounting bracket.
2. Secure the mounting bracket to the radiation shield using a #8 flat washer, #8
split lock washer, and #8 hex nut on each of the screw ends.
3. Hold the mounting bracket against the pipe and slide the ends of the two 1 1/2”
U-bolts through the holes in the back of the mounting bracket so that the U-
bolts wrap around the pipe.
#8 Lock Washer
#8 Hex Nut
#8 Flat Washer
Complete Plate
Assembly