DAVIS Envoy8X Getting Started Guide - Manual (Page 5)

3
B e f o r e Y o u I n s t a l l E n v o y 8 X
Install the transmitting stations you will be using. Make sure that each
transmitter has a unique Transmitter ID (TX ID). (The factory default on
all transmitters is TX ID 1.) Refer to the transmitting station manual for
information on setting or changing the Transmitter ID.
You will need to know the Transmitter ID and transmitting station type
(such as Vantage Pro2 ISS or Leaf Wetness & Soil Moisture/
Temperature) when you configure the Envoy8X. If any transmitting
station is going through a repeater or repeaters, you will also need the
Repeater ID (A-H) of the last repeater before the Envoy8X. List your
transmitters and repeaters to refer to during setup of your Envoy8X.
Note: You can add transmitting stations in the future. Make sure that you assign
each an unused Transmitter ID.
Transmitting Station
Type
TX ID
(1-8)
Repeater
ID
(A-H)
Transmitting Station
Location