Sper Scientific 860031 pH - mV Bench-Top Meter - Manual (Page 45)

45
MEASUREMENT PROCEDURES
Note…
pH and conductivity probes CANNOT be placed in the
same container while taking measurements.
Improper measurement procedure Proper measurement procedure
Automatic Temperature Compensation
pH Probe
Plug the temperature connector sensor into the ATC port at
the rear of the meter.
Conductivity Probe
The temperature sensor is built into the conductivity probe.
Plug the probe only into the MIC port at the rear of the
meter.
Manual Temperature Compensation
pH Probe
1. Disconnect the temperature connector from the rear of
the meter.