Sper Scientific 860031 pH - mV Bench-Top Meter - Manual (Page 44)

44
MEASUREMENT PROCEDURES
6. Press MODE to switch between TDS and CON/SALT.
Salinity Measurement
Use a conductivity probe to measure salinity range: 0 ~ 80
ppt (NaCl) with temperature compensations and
temperature coefficient settings.
Before measuring, remove the probe cover if needed. To
measure:
1. Rinse the probe with de-ionized or distilled water.
2. Press POWER to turn the meter on. Press MODE to
select salinity measurement.
3. Immerse the probe tip (glass bulb) completely into the
sample.
4. Stir the probe gently to create a uniform sample.
5. Wait until the reading has stabilized. If enabled in setup,
“READY” will illuminate to indicate a stable reading.
6. Press MODE to switch between SALT and CON/TDS.