Sper Scientific 860031 pH - mV Bench-Top Meter - Manual (Page 18)

18
SETUP MODE
View Slope & Offset (pH Probe)
1. Press MODE to select the probe type as pH.
2. Press SET for 2 seconds to enter setup.
3. Press ▲ until “ELE” appears in the middle display and
P3.0 appears in the lower display.
4. Press to enter P3.1, the LCD displays one of
four available slope values; P3.1, P3.2, P3.3, P3.4. If
the value is less than 75% or more than 115%, change
the probe immediately.
5. Press to enter P3.2, P3.3, and P3.4.
Note...
The solution range differs between NIST and Custom
buffers.