Sper Scientific 860031 pH - mV Bench-Top Meter - Manual (Page 24)

24
SETUP MODE
P5.2 will appear on the lower portion.
6. To adjust the temperature coefficient from 2.1, press ▲
or ▼. Press to confirm and enter P5.3.
Note…
When using Manual Temperature Compensation Mode
(MTC), you must set the temperature solution in P5.3.
7. At P5.1, press twice to enter P5.3. The default
“25.0” flashes on the middle of the LCD and P5.3 will
appear on the lower portion. To adjust the solution
temperature setting, press ▲ or ▼.
8. Press to confirm and enter P5.4.
Note…
When using the TDS measurement mode, you must set
the TDS conversion factor in P5.4.
9. At P5.1, press three times to enter P5.4. The
default “0.500” flashes on the middle of the LCD and
P5.4 will appear on the lower portion. If the TDS
conversion factor of the solution is not 0.5, press ▲ or