Sper Scientific 860031 pH - mV Bench-Top Meter - Manual (Page 23)

23
SETUP MODE
Temperature Setting (Conductivity Probe)
Use this program to set the temperature parameters and
TDS conversion factors.
1. Press MODE to select the probe program.
2. Press SET for 2 seconds to enter setup.
3. Press ▲ to select COEF. “COEF” will appear on the
middle of the LCD and P5.0 will appear on the lower
portion.
4. Press to enter P5.1. The default “Auto” flashes on
the middle of the LCD and P5.1 will appear on the lower
portion. To switch to manual temperature compensation
mode, press ▲ to change the status, then press to
confirm and enter P5.2.
5. The default “2.1” flashes on the middle of the LCD and