PowerTap Joule GPS User Guide - Manual (Page 15)

Joule GPS User Guide page 15
CHAPTER 3: DASHBOARDS
INTERVALS continued
When using intervals, the Joule GPS can operate in one of two modes: Lap Mode or Interval Mode. These modes refer
to the action taken when the [INTERVAL] button is pressed. The default is Lap Mode. The mode can be changed in the
Record Control section of the Device menu (see chapter 8).
• Lap Mode refers to the traditional way the interval button has operated on all computers from PowerTap: Pressing
the [INTERVAL] button completes one interval (or Lap) and begins the next interval (Lap). Interval 0 (zero), or Lap 0,
is the time recorded from the start of the ride to the first [INTERVAL] button press. The next button press completes
Lap 1 and begins Lap 2. The next button press completes Lap 2 and begins Lap 3, and so on...
• Interval Mode refers to tracking a rider’s intervals as opposed to laps. When the Joule GPS is set to record in
Interval Mode, the first press of the [INTERVAL] button begins interval 1. The next press of the button ends interval
one. The next press of the button begins interval 2. The next press of the button ends interval 2, and so on... The
period between intervals is referred to as the “rest” period in the Joule title bar but the rest/recovery period is not
listed on the Interval dashboard. Only intervals are listed on the Interval dashboard.
Below, the represents when the [INTERVAL] button is pushed.
INTERVAL MODE
Interval 1
Interval 2
LAP MODE
Start Ride
Lap 0
Lap 1
Lap 2
Lap 3
Lap 4
Start Ride