GE PGP990SENSS - Manual (Page 30)

30
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at:
GEAppliances.com
/3&RQYHUVLRQ *DV&RRNWRS
,QVWUXFWLRQV
Read these instructions completely and carefully.
•
,03257$17²
Save these instructions
for local inspector’s use.
•
,03257$17²
Observe all governing
codes and ordinances.
• 1RWHWR,QVWDOOHU² Be sure to leave these
instructions with the Consumer.
• 1RWHWR&RQVXPHU² Keep these instructions
for future reference.
B()25(<28%(*,1
• This cooktop is factory set for natural gas operation.
Conversion to LP operation should be performed by a
qualified technician or installer. Keep these instructions
for future reference. When converting to LP, save the
original parts for possible future use.
• Product failure due to improper installation is not
covered under the GE Appliance Warranty.
:$51,1*²
If you are using LP (bottled) gas,
all adjustments described in the following steps must be
made before attempting burner adjustments or use of the
cooktop.
:$51,1*²
This conversion kit shall be
installed by a qualified service agency in accordance
with the manufacturer’s instructions and all applicable
codes and requirements of the authority having
jurisdiction. If the information in these instructions is
not followed exactly, a fire, explosion or production of
carbon monoxide may result, causing property damage,
personal injury or loss of life. The qualified service agency
is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation
of the converted appliance is checked as specified in the
manufacturer’s instructions supplied with the kit.
)25<2856$)(7<
Adjustable wrench
722/6<28:,//1(('
3$57 48$17,7<
Brass orifices
4
Stick-on conversion label 1
3$576,1&/8'('
Small, thin-blade flat screwdriver with approximately 1/8”
blade width is needed to access the calibration screw.