GE PGP990SENSS - Manual (Page 10)

To Remove the Grill Module:
1. Make sure that all control knobs are set to
OFF and all grill components are cool.
2. Remove the grill grate.
3. Lift the grill burner up slightly and pull it
away from the white slotted receptacle and
brass orifices. Lift it out of the basin when it
is completely unplugged.
4. Do not store or stack modules where they
could fall or be damaged.
NOTE:The optional sealed burner module
JXGB91B can replace the grill burner assembly.
Surface burner and grill modules.
Throughout this manual, features and appearance may vary from your model.
10
Sealed Burner Module
To Install the Sealed Burner Module:
1. Make sure that all control knobs are set to
OFF.
2. Clean the cooktop basin to remove any
grease accumulation. See the Care and
Cleaning the Cooktop section.
3. With the back of the burner module tilted up
and the two round openings and three pins
facing toward the front, insert the module in
the cooktop basin.
4. Slide the burner module forward until the
pins start to engage the white slotted
receptacle.
5. Lower the back of the module into place and
carefully slide it forward until the pins are
fully engaged.
6. Place the burner caps on the burners.
Carefully place the grate onto the module
with the two tabs on the underside toward
the center of the cooktop.
To Remove the Sealed Burner Module:
1. Make sure that all control knobs are set to
OFF and that the cooktop is cool.
2. Lift up the edge of the burner module until
the bottom of the module clears the edge of
the basin.
IMPORTANT: Do not lift the module too high
ZKLOHLWLVVWLOOFRQQHFWHG³\RXFRXOGGDPDJH
the ignitor rods and mixer tubes.
3. Hold the module by the sides and pull it
away from the slotted receptacle and brass
orifices. Lift it out of the basin when it is
completely unplugged.
4. Do not store or stack modules where they
could fall or be damaged.
NOTE: The optional sealed burner module
JXGB91B can replace the grill burner assembly.
Grill Module
To Install the Grill Module:
1. Make sure that all control knobs are set to
OFF.
2. Position the grill burner with the two round
tubes and three pins facing the front.
3. Slide the grill burner forward until the pins
and ignitors are engaged in the white slotted
receptacle; then lower the burner until it
rests on the mounting pins.
4. Carefully place the grill grate on the cooktop.
The grate is designed to fit one way only.
See the illustration.
NOTE: Before using the grill for the first time,
heat the grill burner to remove the protective
shipping coating. Heat the grill burner on HI for
10 minutes and use the vent system to remove
any additional smoke during cooling.
The grill consists of a black grill grate and the grill burner. Only install the grill on the left side of your
cooktop.