HP e-Commerce Server Accelerator sa7120 - Manual (Page 110)

C H A P T E R 6 HP e-Commerce Server Accelerator SA7100/SA7120 User Guide
100
Changing the
SSH Port The SSH port is set and displayed by using the CLI commands set
ssh_port > and show ssh_por t.
These commands are available only at the local serial console and
when the remote management is enabled. By default, the SSH port
number is 22.
To set the SSH port:
HP SA7120> set ssh_port 220
To display the SSH port:
HP SA7120> show ssh_port
SSH Port Number: 22 0
Disabling SSH SSH sessions are disabled at the SA7100/SA7120’s local serial
console. To disable, follow the steps below:
HP SA7120> set ssh disable
To verify SSH disable:
HP SA7120> show ssh
SSH: disable
To ensure that SSH sessions remain disabled across a device
shutdown and startup, run the config save command.
SNMP
The HP e-Commerce Server Accelerator SA7100/SA7120 has a
fully compliant, embedded SNMP agent that supports SNMPv1 and
SNMPv2c requests. In addition to standard MIB-II, HP private
enterprise MIBs provide the following capabilities:
• Monitor the health of the SA7100/SA7120’s hardware and
network links
• Monitor the flags used to enable and disable alarms and monitors
• Monitor the SA7100/SA7120’s load as indicated by CPU
utilization, connection count, and connections per second
• Monitor status and performance of SSL encryption and
decryption functions
• Monitor overloads, spills, and throttles