HP 6400.8400 Enterprise Virtual Array - Manual (Page 49)

Testing connections to the EVA
After installing the FCAs, you can create and test connections between the host server and the
EVA. For all operating systems, you must:
•
Add hosts
•
Create and present virtual disks
•
Verify virtual disks from the hosts
The following sections provide information that applies to all operating systems. For OS-specific
details, see the applicable operating system section.
Adding hosts
To add hosts using HP P6000 Command View:
1. Retrieve and note the worldwide names (WWNs) for each FCA on your host.
You need this information to select the host FCAs in HP P6000 Command View.
2. Use HP P6000 Command View to add the host and each FCA installed in the host system.
NOTE: To add hosts using HP P6000 Command View, you must add each FCA installed in
the host. Select Add Host to add the first adapter. To add subsequent adapters, select Add
Port. Ensure that you add a port for each active FCA.
3. Select the applicable operating system for the host mode.
Table 15 Select the host mode for the applicable operating system
Host mode selection Operating System
HP-UX HP-UX
IBM AIX IBM AIX
Linux Linux
Linux Mac OS X
OVMS OpenVMS
Sun Solaris Oracle Solaris
VMware VMware
Microsoft Windows Windows
Microsoft Windows 2008
Microsoft Windows 2012
Linux Citrix Xen Server
4. Check the Host folder in the navigation pane of HP P6000 Command View to verify that the
host FCAs are added.
NOTE: More information about HP P6000 Command View is available at http://
www.hp.com/support/manuals . Click Storage Software under Storage, and then select HP
P6000 Command View software under Storage Device Management Software.
Creating and presenting virtual disks
To create and present virtual disks to the host server:
Testing connections to the EVA 49