HP 6400.8400 Enterprise Virtual Array - Manual (Page 106)

Table 22 Error Messages (continued)
How to Correct Meaning Status Code Value
Report the error to product support. The disk group is in a redundancy mirrored
inoperative state and the request cannot be
completed. 91
Redundancy Mirrored Inoperative
Select another LUN number and retry
the request. The LUN number is already in use by
another client of the storage system. 92
Duplicate LUN
Resolve the condition and retry the
request. Report the error to product
support. While the request was being performed, the
remote storage system controller failed. 93
Other remote controller failed
Correctly select the remote storage
system and retry the request. The remote storage system specified does
not exist. 94
Unknown remote Vdisk
Correctly select the remote Continuous
Access group retry the request. The remote Continuous Access group
specified does not exist. 95
Unknown remote DR group
Resolve the condition and retry the
request. Report the error to product
support. The disk metadata was unable to be
updated. 96
PLDMC failed
Retry the request later. Another process has already taken the SCMI
lock on the storage system. 97
Storage system could not be
locked. System busy. Try
command again.
'Resolve the condition and retry the
request While the request was being performed, an
error occurred on the remote storage system. 98
Error on remote storage system.
Resolve the condition and retry the
request. The request failed because the operation
cannot be performed on a Continuous
Access connection that is up. 99
The DR operation can only be
completed when the
source-destination connection is
down. If you are doing a
destination DR deletion, make
sure the connection link to the
source DR system is down or do
a failover operation to make this
system the source.
The storage system password may
have been re-configured or removed. The management software is unable to log
into the device as the password has
changed. 100
Login required - password
changed.
The management software must be
used to set the password up to match
the device so communication can
proceed.
106 Error messages