HP 6400.8400 Enterprise Virtual Array - Manual (Page 121)

Windows Server (64-bit) configuration
Requirements
•
Switch zoning or controller level SSP must be used to ensure each single path HBA has an
exclusive path to its LUNs.
•
Single path HBA server can be in the same fabric as servers with multiple HBAs.
•
Single path HBA server cannot share LUNs with any other HBAs.
HBA configuration
•
Hosts 1 and 2 are single path HBA hosts.
•
Host 3 is a multiple HBA host with multi-pathing software.
See Figure 34 (page 122) .
NOTE: Single path HBA servers running the Windows Server 2003 (x64) operating system will
support multiple single path HBAs in the same server. This is accomplished through a combination
of switch zoning and controller level SSP. Any single path HBA server will support up to four single
path HBAs.
Risks
•
Single path failure will result in loss of connection with the storage system.
•
Single path failure may cause the server to reboot.
•
Controller shutdown puts controller in a failed state that results in loss of data accessibility
and loss of host data that has not been written to storage.
NOTE: For additional risks, see “Windows Server failure scenarios” (page 132) .
Limitations
•
HP P6000 Continuous Access is not supported with single path configurations.
•
Single path HBA server is not part of a cluster.
•
Booting from the SAN is not supported on single path HBA servers.
Supported configurations 121