HP StorageWorks All-in-One SB600c Storage Blade - Manual (Page 31)

Memory options
The HP AiO SB600c Server Blade is configured with 2 GB of memory. The server contains eight FBDIMM
slots and the Operating System can address up to 4 GB of memory. Using the Advanced Memory
Protection options will allow 4 GB more of memory to be used as an online spare or mirrored memory.
See http://www.hp.com for more information.
Installing FBDIMMs
To install the component:
1. Power down the server blade.
See
Powering down the HP All-in-One SB600c Storage Blade Solution on page 19 for more
information.
2. Remove the server blade. See Removing the HP AiO SB600c Server Blade on page 20 for more
information.
3. Remove the access panel. See 21 for more information.
4. Install the FBDIMM.
Figure 5 Installing FBDIMMs
5. Install the access panel. See Installing the access panel on page 22 for more information.
6. Install the server blade.
See
Installing the HP AiO SB600c Server and Storage Blades on page 13 for more information.
7. Power up the server blade.
See
Powering up the HP All-in-One SB600c Storage Blade Solution on page 19 for more information.
Mezzanine card option
Optional mezzanine cards are classified as Type I mezzanine cards and Type II mezzanine cards.
The card type determines where it can be installed in the server blade. Optional mezzanine cards
enable network connectivity and provide Fibre Channel support. For mezzanine card locations, see
System board components on page 48 for more information.
• Install Type I mezzanine cards on either mezzanine 1 connector or mezzanine 2 connector.
All-in-One SB600c Storage Blade Solution 31