HP StorageWorks All-in-One SB600c Storage Blade - Manual (Page 22)

CAUTION:
To prevent damage to electrical components, properly ground the server blade before beginning any
installation procedure. Improper grounding can cause ESD.
Installing the access panel
1. Place the access panel on top of the server blade with the hood latch open. Allow the panel to
extend past the rear of the server blade approximately 0.8 cm (0.2 in).
2. Engage the anchoring pin with the corresponding hole in the latch.
3. Push down on the hood latch. The access panel slides to a closed position.
22 Operations