HP Netserver L Server series - Manual (Page 30)

Chapter 3 Opening and Closing the
HP NetServer
22
7. Both people must carefully pull the satellite chassis off the slides (Figure
3-5). Place the satellite carefully on a nearby work surface.
Figure 3-5. Pulling the Satellite Chassis Off Its Slides
8. To replace the satellite chassis, move to the front of the server and unlatch
all four power supplies. (If the front bezel is in place, remove it. See
"Removing and Replacing the Front Bezel." Then make sure that the
slides are locked in the fully-extended position behind the base chassis.
NOTE Before putting the satellite back on the base chassis, make sure
that the power interlock switch on the back of the base chassis
is still in the unlocked position (Figure 2-6). Otherwise, you
cannot slide the satellite all the way onto the base.