HP Netserver L Server series - Manual (Page 27)

Chapter 3 Opening and Closing the
HP NetServer
19
Ejector Handles
Figure 3-3. Sliding Out the Satellite Chassis
Redocking the Satellite Chassis
1. When you finish servicing the HP NetServer, move to the front of the
server and unlatch all four power supplies. (If the front bezel is in place,
remove it. See "Removing and Replacing the Front Bezel."
2. At the rear, insert the satellite chassis. To do so, push in the release latch
for each slide (Figure 3-4). While holding the latches down, push the
satellite part-way onto the base, so that the latches can no longer engage.