Setting up linux servers to be managed by hp sim, Running hpsum in linux environment – HP Systems Insight Manager User Manual
Page 32
2.
Verify that SysFaultMgmt provider is installed.
Depending on the System Fault Manager configuration, run the following:
cimprovider –lm SFMProviderModule
The EMSWrapperProvider appears.
or
cimprovider –ls
The EMSWrapperProvider appears.
NOTE:
For more information regarding System Fault Manager, see
.
3.
From the CMS:
To subscribe to WBEM Events, you must have root access. You can verify what credentials
are used for WBEM access by running the following command line:
mxnodesecurity –l –p wbem –n
If the managed system does not have a root level user credential configured, you can add it
for the individual system.
NOTE:
You can use the Configure or Repair Agents tool in the HP SIM UI to perform this
step without permanently recording a root password.
•
To change the individual system:
mxnodesecurity -a -p WBEM -c \
<username:password> -n <systemname>
4.
From the CMS, run the WBEM Indications/Events command line:
mxwbemsub -l -n <systemname>
For more information on subscribing and unsubscribing to WBEM indications, see the HP SIM
online help.
Setting up Linux servers to be managed by HP SIM
To be fully managed by HP SIM, HP ProLiant servers running Linux should have the Insight
Management Advisor installed. These agents are part of the ProLiant Support Pack. You can install
the ProLiant Support Pack manually, or configure it to be installed as part of your normal operating
system deployment procedures.
After setting up the management agents on the managed systems, the rest of the configuration can
be done from the HP SIM UI. Continue to Chapter 4
for further information.
Running HPSUM in Linux environment
To run HPSUM in Linux environment enable the port required for HPSUM. The following table
describes the HP SUM Linux network ports:
Table 3 HP SUM Linux network ports
Description
Ports
This port establishes a connection to a remote node via SSH to perform node inventory.
Port 22
This port is a secure data port used to transfer information.
Port 443
This port is default for some internal communications. It listens to the remote side if there is no
conflict. If a conflict occurs, the next available port is used.
Port 62286
32
Setting up managed systems