HP Integrity BL870c Server-Blade - Manual (Page 34)

Figure 2 Anchor Rod Assembly For Raised Floor
7 Raised floor 1 Socket head bolt cap
2 Spring washer 8 Saddle nut
9 Raised floor channel 3 Flat washer
4 Nylon bushing 10 Concrete floor
11 Access floor pedestal 5 Drip plate (included in rack
accessory kit)
12 Rack leveling foot
6 Rack base
6. Thread the saddle nut onto the bottom of the bolt and drop the saddle nut into the site’s
u-channel under the raised floor.
7. Using a 24-mm (15/16”) socket, torque the anchor bolt to 58 ft-lbs (77 N-m).
8. Reconnect the ground wire to the kickplate and install the kickplate at the bottom of the rack.
Join Adjacent Cabinets Together (Optional)
If you will be joining the cabinets together, ensure that the cabinets are located within a 27-inch
(68.6 cm) pitch. The space between the cabinets should be approximately 0.33 inch (8.3 mm).
NOTE: This procedure can be used to join two seismic racks, two R2 seismic racks , or a seismic
rack to a seismic rack R2. You must use the L-shaped bracket included in the accessory kit (P/N
647475-001) to join R2 seismic racks to any other seismic rack.
34 Installing the Seismic Rack