HP Integrity BL870c Server-Blade - Manual (Page 24)

Removing the Side Panels
If your rack has side panels, also remove them before installing mounting brackets and other
hardware.
1.
For the seismic rack: Use a slotted screwdriver to gently unfasten the four quarter-turn fasteners
from the side panel.
For the seismic rack R2: Using a T30 torx screwdriver, unscrew the six screws per side panel.
Pull down on the side panel's latch and lift the panel up and out of the bottom of the rack.
2. Disconnect the ground cable from the lower inside corner of the side panel using an 11–mm
socket wrench.
3. Lift the side panel from the rail on which it is mounted, and remove it from the rack.
To reinstall the side panels, reverse the procedure.
Removing the Kickplate
Remove the kickplates from the front and rear base of the rack to access the rack anchor bolts. To
remove a kickplate:
24 Installing the Seismic Rack