HP Lights-Out 100 Remote Management - Manual (Page 26)

Using LO100 26
4. Scroll to Realtime Sensor Data by pressing the down arrow ( ↓ ) key. Press the Enter key.
The
Loading data. Please wait
message appears. After this message disappears, the
Temperature and Voltage sensor data appears. This data is real-time data and is updated on a
periodic basis.
Platform event filtering configuration
The PEF Configuration screen enables you to configure LO100 to take selected actions on received or
internally generated event messages. These actions include powering down the system, system reset, and
triggering the generation of an alert.
If you want to enable PEF functionality you must issue the following commands in the CLP:
cd map1
oemhp i 20 10 D0 18 00 12 01 03 D2
oemhp i 20 10 D0 18 00 12 02 3F 95
To configure a PEF for a particular sensor, click the PEF button to the far right of that sensor on the
Monitoring Sensors screen. The PEF button adjacent to each sensor opens a PEF Configuration page for
that sensor.
The PEF Configuration screen contains two sections: Current PEF Entries and Add PEF Entry. The Current
PEF Entries section includes Sensor Type, Sensor Name, PEF Action, and PEF Control information. The
Add PEF Entry section enables you set an action.
Initially, no entries are in the Current PEF Entries section because no PEFs are defined. When PEF entries
are defined, the PEF Control field is active and allows individual entries to be enabled, disabled, or
deleted.
To configure an action (PEF entry) select the desired Event Offsets and PEF Action settings and click Add.
• Event Offsets are trip points (movements across thresholds) that define what type of sensor event
triggers an action. The information in the Events Offsets section varies with the type of sensor. Not all
options are available for all sensors. You can select any of the available options.
• PEF Action displays the same information for all sensors:
o Sensor Type displays the type of sensor selected.
o Sensor Name displays the name of the sensor.