HP Lights-Out 100 Remote Management - Manual (Page 13)

Configuration 13
2. Open the
/etc/xinetd.d/tftp
file and modify the parameter
server_args
to include
-T
15000000
. For example,
server_args = -c -s /tftpboot -T 15000000
.
3. If a firewall is enabled, disable it or modify the settings to allow the firewall to connect to the TFTP
port. To change the firewall settings, navigate to Applications>System Settings>Security Level, and
enter
69:udp
in the parameter of the other port.
To update the firmware, log in to LO100 as the administrator through the CLP interface, and issue the
load
command to upload and install the firmware from the map1/firmware directory.
1. Start a CLP session. To access CLP:
a. Navigate to Start>All Programs>Accessories>Command Prompt.
b. At the command prompt, enter
telnet
.
2. At the CLP prompt, enter
cd map1/firmware
.
3. At the CLP prompt, enter
load -source -oemhpfiletype csr
where:
o is the
///
to be downloaded.
o is the URL or IP address of the TFTP server containing the firmware.
o is the file name of the image file (LdrImage.bin in this example).
For example, enter
load -source //10.141.38.157/LdrImage.bin - oemhpfiletype
csr
.
The TFTP application might report an error in the early part of the firmware upload process, during
the firmware image validation process. An error does not necessarily indicate failure of the firmware
upload and does not prevent successful firmware uploads. A successful firmware upload typically
takes several minutes. After the firmware upgrade process is complete, verify that the new version of
the firmware is active.
If the firmware upgrade process fails after sufficient time (at least 5 minutes), reboot the server, and
verify that the previous version of the firmware is still active. Always reboot the server before retrying
the firmware upgrade process.
After installing the firmware, the IP address of the server might reset to the default value. You must
locally reset the IP address to the desired address.
NOTE: After using the
load
command LO100 will reset ending your CLP interface session.
You must reconnect to the CLP interface.
NOTE: When you use the CLP
load
command with TFTPD32, HP recommends using a 30-
second timeout and 6 retries.
Flashing previous firmware versions on an HP ProLiant ML110
G5 Server
When an HP Lights-Out 100c Remote Management Card is installed in an HP ProLiant ML110 G5 Server,
you can flash the LO100 to an earlier version. In the map1 directory, enter the CLP command
oemhp i
20 20 c0 18 00 04 04 e0
. This command reactivates the previous version.