HP XP Business Copy Software - Manual (Page 107)

Table 48 CQUERY Command Parameters
Value Parameter
Device number. DEVN
Figure 48 (page 107) shows an example of the CQUERY command.
Figure 48 CQUERY Command
14.27.58 JOB04573 ANTP8802I CQUERY DEVN(6400)
14.27.58 JOB04573 ANTP0090I CQUERY FORMATTED LVL 4 220
220 VOLUME REPORT
220 ************** PPRC REMOTE COPY CQUERY - VOLUME ********************
220 * (PRIMARY) (SECONDARY) *
220 * SSID CCA LSS SSID CCA LSS*
220 *DEVICE LEVEL STATE PATH STATUS SERIAL# SERIAL# *
220 *------ --------- ---------- ----------- --------- --------- *
220 * 6400 PRIMARY.. DUPLEX.... ACTIVE.. 2700 00 00 2700 01 00 *
220 * CRIT(NO)....... CGRPLB(NO). 000000063515 000000063515*
220 * INCRES(NO). *
220 * PATHS SAID DEST STATUS: DESCRIPTION *
220 * ----- --------- ------ ------------------- *
220 * 1 FFFF FFFF 01 PATH ESTABLISHED... *
220 * ---- ---- 00 NO PATH............ *
220 * ---- ---- 00 NO PATH............ *
220 * ---- ---- 00 NO PATH............ *
220 * SUBSYSTEM WWNN LIC LEVEL *
220 * ----------- ---------------- ----------- *
220 * PRIMARY.... 0000000000000000 80.9.6.255 *
220 ********************************************************************
14.27.59 JOB04573 ANTP0001I CQUERY COMMAND COMPLETED FOR DEVICE 6400. COMPLETION CODE: 00
When a command is issued to the target volume (T-VOL) in a CTG, the serial number of the
SECONDARY is displayed in the last part of the following five-part format.
SECONDARY serial number Split using At-Time Split
operation Belongs to CTG
30158 000 @ S 00
00: Indicates the serial number of SECONDARY.
S indicates that the volume belongs to a CTG.
@ indicates a split using the At-Time Split operation with the ATSPLIT command.
000: Indicates that the pair belongs to a CTG.
30158 indicates the SECONDARY serial number.
QUERY
Table 49 (page 107) lists and describes the QUERY command parameters that can be used when
you see the status of SIz pairs.
Table 49 QUERY Command Parameters
Description Value Parameter
You should specify only one parameter of the
three parameters. The italic part on the left
means that it is the arbitrary name. For
example, dname means the arbitrary unique
name of the JCL statement which identifies the
volume. DDNAME = dname = JCL statement identifying
the volume.
SYSNAME = sysxxx = SYSNAME in the
ASSGN system control statement.
UNITADDRESS = ccuu = device number.
DDNAME,
SYSNAME, or
UNITADDRESS
Figure 49 (page 108) shows an example of the QUERY command.
Displaying Pair Status Using PPRC Commands 107