HP XP P9500 Storage User Manual

Page 38

START KTSETENV,PARM='YKLCNSE=HPQ1'

START KTSETENV,PARM='YKLCNS2=HPQ2'

•

When specifying whether to use the system logger service to collect event logs

START KTSETENV,PARM='LOGPUT=LOGR'

(if using the system logger service)

START KTSETENV,PARM='LOGPUT=SAM'

(if not using the system logger service)

•

When specifying whether to output CLI command execution logs to SYSLOG

START KTSETENV,PARM='SYSLOG=YES'

(if outputting to SYSLOG)

START KTSETENV,PARM='SYSLOG=NO'

(if not outputting to SYSLOG)

TIP:

This setting is invalidated if an IPL is performed again. We recommend that you perform either of the
following settings in case that you need to perform an IPL again the next time:

•

Add the

KTSETENV

command to the

COMMNDxx

parmlib member to automatically set the envir-

onment variables when an IPL is performed again.

•

For the

IEASYMxx

parmlib member, specify the system symbols so that the statically-registered

settings will be used the next time an IPL is performed.

TIP:

We recommend that you use either the environment variables or the system symbols to specify both

prefix-1

and

prefix-2

. If you use the environment variable to specify

prefix-1

and use the

system symbol to specify

prefix-2

, the process of determining the prefixes will be complicated.

TIP:

The license (name of the license information dataset) for Smart Manager for Mainframe takes effect
when the

KTLOAD

command is first executed after the license is registered. Even if you used the

KTSETENV

command to modify a prefix of the license information dataset name while CLI commands

were being executed, the corresponding license takes effect after the

KTLOAD

command is executed

the next time.

CAUTION:

Environment variables are shared by Smart Manager for Mainframe and Business Continuity Manager.
Therefore, you must be careful when setting the environment variables in an environment where
Business Continuity Manager is installed.

Operations to be performed in the next step

•

Settings required for registering a license in the ISPF panel

Installation and Setup