HP XP P9500 Storage - Manual (Page 37)

Default
values Specified val-
ues
System symbols
Environ-
ment vari-
able
Setting items
LOGR
LOGR : Used
SAM : Not used
&YKLOGPT LOGPUT
Specifies whether the system logger ser-
vice is used to collect event logs.
YES
YES : Output
NO : Not output
&YKSYSLG SYSLOG
Specifies whether to output CLI command
execution logs to SYSLOG.
#:
The name of a license information dataset is decided as follows:
prefix-1.prefix-2.CCENTRAL.LICENSE
prefix-2
can be omitted.
prefix-2
is enabled if
prefix-1
is specified.
If you set both the environment variables and the system symbols, the priority is as follows:
1. Values of the environment variables
2. Values specified for the system symbols
3. Default values
Setting the operating environment by using environment variables
To dynamically set the following operating environments by using environment variables, use the
environment setting command
KTSETENV .
• The prefix of the license information dataset that registers the license key
• Whether the system logger service is used to collect event logs
• Whether CLI command logs are output to SYSLOG
Prerequisites
• Settings for using environment configuration commands
To set the operating environment by using environment variables:
1. Execute the following KTSETENV command.
START KTSETENV,PARM='parameter=parameter-value'
2. Use the KTDSPENV command as follows to confirm that the environment variables have been
specified correctly:
START KTDSPENV,PARM='DETAIL'
Example of executing the KTSETENV command
• When setting the name of the license information dataset to HPQ1.HPQ2.CCENTRAL.LICENSE
User Guide 37