HP XP P9500 Storage - Manual (Page 31)

• Example of dynamically linking the LINKLIB load library to LNKLST , page 31
Example of dynamically linking the LINKLIB load library to LNKLST
This section explains an example of dynamically linking the LINKLIB load library to LNKLST .
In this example, the currently-active LNKLST is switched from the original LNKLST to a temporary
LNKLST , and during this time, the original LNKLST is connected to the LINKLIB load library. Dynamic
changing of LNKLST affects the jobs that are currently being executed. Before carrying out this
procedure, see the IBM manual relating to
LNKLST
, and check the required notes on dynamically
changing LNKLST .
1. Determine the active LNKLST by issuing the following command.
D PROG,LNKLST
The currently-active LNKLST (original LNKLST ) is assumed to be LNKLST00 .
2. Copy LNKLST00 , and then define a temporary LNKLST ( LNKLST99 ).
SETPROG LNKLST,DEFINE,NAME=LNKLST99,COPYFROM=LNKLST00
3. Activate temporary LNKLST ( LNKLST99 ).
SETPROG LNKLST,ACTIVATE,NAME=LNKLST99
4. Apply all jobs that are being executed to the temporary LNKLST ( LNKLST99 ).
SETPROG LNKLST,UPDATE,JOB=*
5. Add the LINKLIB load library to the original LNKLST ( LNKLST00 ).
SETPROG LNKLST,ADD,NAME=LNKLST00,DSN=loadlib_dataset_name
6. Reactivate original LNKLST ( LNKLST00 ).
SETPROG LNKLST,ACTIVATE,NAME=LNKLST00
7. Re-apply all jobs that are being executed to the original LNKLST ( LNKLST00 ).
SETPROG LNKLST,UPDATE,JOB=*
8. Remove the temporary LNKLST ( LNKLST99 ).
SETPROG LNKLST,UNDEFINE,NAME=LNKLST99
For details on the SETPROG command, see the manual MVS System Commands.
Setting RACF security for CLI commands
To use Smart Manager for Mainframe CLI commands, you must set up RACF security. Assign user
permissions to use CLI operation commands or CLI reference commands.
User Guide 31