Set or change the product password, Link speed and duplex settings – HP LaserJet Pro CP1525nw Color Printer User Manual
Page 55
xxxx::xxxx:xxxx:xxxx:xxxx
2.
To open the embedded Web server, type the IP address into the address line of a Web browser.
3.
Click the Networking tab to obtain network information. You can change settings as needed.
Set or change the product password
Use the HP Embedded Web Server to set a password or change an existing password for a product on
a network.
1.
Type the product IP address into the address line of a Web browser. Click the Networking tab,
and click the Security link.
NOTE:
If a password has previously been set, you are prompted to type the password. Type the
password, and then click the Apply button.
2.
Type the new password in the New Password box and in the Verify password box.
3.
At the bottom of the window, click the Apply button to save the password.
Manually configure IPv4 TCP/IP parameters from the control panel
1.
On the control panel, press the Setup button.
2.
Use the arrow buttons to select the Network configuration option, and then press the
OK
button.
3.
Use the arrow buttons to select the TCP/IP configuration option, and then press the
OK
button.
4.
Use the arrow buttons to select the Manual option, and then press the
OK
button.
5.
Use the alphanumeric buttons to type the IP address, and then press the
OK
button.
6.
If the IP address is incorrect, use the arrow buttons to select the No option, and then press the
OK
button. Repeat step 5 with the correct IP address, and then repeat step 5 for the subnet mask
and default gateway settings.
Link speed and duplex settings
NOTE:
This information applies only to Ethernet networks. It does not apply to wireless networks.
NOTE:
Incorrect changes to the link speed setting might prevent the product from communicating with
other network devices. For most situations, the product should be left in automatic mode. Changes can
cause the product to turn off and then on. Changes should be made only while the product is idle.
1.
On the control panel, press the Setup option.
2.
Use the arrow buttons to select the Network configuration option, and then press the
OK
button.
3.
Use the arrow buttons to select the Link speed option, and then press the
OK
button.
4.
Use the arrow buttons to select one of the following settings.
●
Automatic
●
10T Full
●
10T Half
ENWW
Connect to a network
41