Enww interpret control panel messages 121 – HP LaserJet Pro CP1525nw Color Printer User Manual
Page 135
Control panel message
Status alert
Description
Recommended action
Cyan Very Low
The print cartridge is at the end of
its useful life, and the At Very
Low menu item in the System
Setup menu is set to Continue.
To ensure optimal print quality,
HP recommends replacing the
print cartridge at this point. You
can continue printing until you
notice a decrease in print quality.
Actual cartridge life may vary.
Once an HP supply has reached
“very low”, HP's premium
Protection Warranty on that
supply has ended. All print
defects or cartridge failures
incurred when an HP supply is
used in continue at very low
mode will not be considered to be
defects in materials or
workmanship in the supply under
the HP Print Cartridge Warranty
Statement.
Device error
Press [OK]
An internal error occurred.
Press
OK
to resume the job.
Front door open
The product front door is open.
Close the door.
Genuine HP supply installed
A genuine HP supply was
installed. This message will
appear briefly after the supply is
installed and then be replaced by
the message Ready.
No action necessary.
Incorrect supplies
More than one print cartridge is
installed in the incorrect slot.
Be sure that each print cartridge
is in the correct slot. From top to
bottom, the print cartridges are
installed in this order: yellow,
magenta, cyan, black.
Install
The print cartridge is either not
installed or not correctly installed
in the product.
Install the print cartridge.
Invalid driver
Press [OK]
You are using an incorrect printer
driver.
Select the correct printer driver.
Jam in
The product has detected a jam.
Clear the jam from the location
indicated. The job should
continue to print. If it does not, try
reprinting the job.
If the message persists, contact
HP support.
Jam in tray #
Clear jam and then Press [OK]
The product has detected a jam.
Clear the jam from the location
indicated, and then press
OK
.
If the message persists, contact
HP support.
Load paper
Tray 2 is empty.
Load paper into Tray 2.
ENWW
Interpret control panel messages 121