HP LaserJet Pro CP1525nw Color Printer - Manual (Page 136)

Control panel message Status alert Description Recommended action
Load tray # A tray is configured for the paper
type and size that the print job is
requesting, but that tray is empty. Load the correct paper into the
tray, or press
OK to use paper in
a different tray.
Load tray 1 plain
Cleaning Page [OK] to start
The product is ready to process
the cleaning operation. Load Tray 1 with plain paper in
the size indicated, and then press
OK .
Load tray 1 No trays are configured for the
paper type and size that the print
job is requesting. Load the correct paper into
Tray 1, or press
OK to use paper
in a different tray.
Magenta Cartridge Low The print cartridge is nearing the
end of its useful life. Printing can continue, but
consider having a replacement
supply on hand.
Magenta in wrong position A print cartridge is installed in the
incorrect slot. Be sure that each print cartridge
is in the correct slot. From front to
rear, the print cartridges are
installed in this order: black,
cyan, magenta, yellow.
Magenta in wrong position The print cartridge is installed in
the incorrect slot. Make sure that each print
cartridge is installed in the correct
slot. From front to back, the print
cartridges are installed in this
order: black, cyan, magenta, and
yellow.
Magenta Very Low The print cartridge is at the end of
its useful life, and the At Very
Low menu item in the System
Setup menu is set to Continue. To ensure optimal print quality,
HP recommends replacing the
print cartridge at this point. You
can continue printing until you
notice a decrease in print quality.
Actual cartridge life may vary.
Once an HP supply has reached
“very low”, HP's premium
Protection Warranty on that
supply has ended. All print
defects or cartridge failures
incurred when an HP supply is
used in continue at very low
mode will not be considered to be
defects in materials or
workmanship in the supply under
the HP Print Cartridge Warranty
Statement.
Manual duplex
Load tray # Press [OK]
The first side of a manual duplex
job has printed, and the page
needs to be loaded to process the
second side. Load the page in the indicated
tray with the side to be printed
face up, and the top of the page
away from you and then press
OK .
Manual feed
Press [OK] for available media
The product is set for manual
feed mode. Press OK to clear the message
or load the correct paper into
Tray 1.
Memory is low
Press [OK]
The product memory is almost
full. Press OK to finish the job, or
press X to cancel the job.
Break the job into smaller jobs
that contain fewer pages.
122 Chapter 10 Solve problems ENWW